Conair VL Series Manual de instrucciones descargar pdf (Pagina 9)

GSL 9-12-12 IM Page 9

5 OPERATION OVERVIEW

Assure that the

feed tube is

inserted into

material

The feed tube joins air with material and it should be plunged (and kept) in the material

supply, but allow upper section of feed tube to remain above material level.

Adjust load time. See next page for detailed instructions on control settings and options.

To allow optimum loading and longest filter life, adjust load time to fill the loader without

over filling. To identify optimal load time, operate the motor until material stops moving

and note the corresponding fill time. This means the loader is OVER FILLED. Subtract 5

seconds from the over-filled time to limit premature filter blinding.

Rotate the feed tube ring for the best air to material mixture. The best mixture of air and

material will allow material to flow efficiently, with the right proportion of conveying air,

without clogging and without rapid hose wear. Be sure material flows into loader

consistently from start to finish, without surging or floating at the pickup or loader inlet.

Vacuum motor should fill loader

until 5 seconds before pellets

stop moving through the convey

hose and no more.

Adjust conveying air

with feed tube ring

Too much air…slow

loading and hose wear

more likely

Too little air…plugged

material line is possible

Good mixture of air

and material

Rotate to

change air

inlet opening

Air inlet

Plastic

Pellets

Press button to

turn on loader and

adjust load time with +

buttons.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Sin comentarios

Conair VL Series Manual de instrucciones Pagina 9