Conair VL Series Manual de instrucciones descargar pdf (Pagina 7)

GSL 9-12-12 IM Page 7

GSL Mounting Flange Patterns

– NOVATEC Compatible

GSL – Mounting to Other Patterns

 Compatible with NOVATEC / Maguire GVL-10

 Compatible with Conair AL2, AL5, DB8 and

DB12 mounting patterns

 New or existing NOVATEC hoppers will allow mounting the GSL directly. Hoppers with

large openings for 5” dump throat models will use the VL-12 to VL-38 adaptor, included with

the GSL unit. You may bolt the loader base plate on the receiving hopper securely, and

then install the GSL cast cone with the front hinge pin and rear flange locking tab.

CAUTION: FASTEN GSL FLANGE TO RIGID MOUNTING SURFACE BEFORE

OPERATING OR TILTING THE HOPPER BODY. USE ONLY LOCKING, CAPTIVE

FASTENERS.



For mounting to non-NOVATEC hoppers, note your model of GSL and prepare the hopper

to be loaded with the appropriate cut-out and bolt pattern according to the diagrams above.

These have been designed to allow for direct mount into several non-NOVATEC mounting

patterns.



Secure fasteners should be employed, fastened permanently to the hopper lid to prevent

possible dropping into the hopper/material.

1 2 3 4 5 6 7 8 9 10 11 12 ... 16 17

Sin comentarios

Conair VL Series Manual de instrucciones Pagina 7